MA 2402

MA 2402 Description:

1,050 watts per channel at two ohms, 800 watts at four ohms, and 520 at eight ohms. Bridgeable to 2,070 watts at four ohms. Grounded Bridge® design for low distortion and high reliability. ODEP output protection to prevent failures; distortion detector; bridge and parallel mono modes; high damping factor; full protection against shorted outs, mismatched loads, I/O DC, overheating, and high frequency overloads; plus much more make it totally flexible for lots of applications. Two balanced 1/4" and XLR ins, two binding post outs. Two RU.

MA 2402 Specifications:

• Load Impedance: Safe with all types of loads. Rated for 2 to 16 ohms in Stereo, 4 to 16 ohms in Bridge-Mono and 1 to 4 ohms in Parallel-Mono mode.
• Required AC Mains: 50/60 Hz; 100, 120, 220 and 240 VAC (10%) units are available. All draw 100 watts or less at idle. Current, voltage and frequency requirements are provided on the units back panel.
• Performance
• Frequency Response: 0.1 dB from 20 Hz to 20 kHz at 1 watt .
• Phase Response: 10 degrees from 10 Hz to 20 kHz at 1 watt .
• Signal-to-Noise Ratio,
• A-weighted: Better than 105 dB below rated full bandwidth power.
• 20 Hz to 20 kHz: Better than 100 dB below full bandwidth power.
• Total Harmonic Distortion (THD) at full bandwidth power: Less than 0.05% from 20 Hz to 1 kHz increasing linearly to 0.1% at 20 kHz.
• Intermodulation Distortion (IMD): (60 Hz and 7 kHz at 4:1) Less than 0.05% from 163 milliwatts to full bandwidth power.
• Damping Factor: Greater than 1,000 from 10 Hz to 400 Hz.
• Slew Rate: (Slew rates are limited to useful levels for ultrasonic/RF protection). Greater than 13 volts per microsecond.
• Controls
• Enable: A front panel push button used to turn the amplifier on and off.
• Level: A front panel rotary control for each channel with 31 detents used to control the output level.
• Stereo/Mono: A three-position back panel switch used to select Stereo, Bridge-Mono or Parallel-Mono mode.
• Sensitivity: A three-position switch inside the PIP compartment used to select the input sensitivity for both channels: 0.775 volts or 1.4 volts for standard 1kHz power, or a 26 dB voltage gain.
• Reset: A back panel push button for each channel used to reset the circuit breaker that protects each power supply.
• Input Ground Lift: This switch on the PIP2-FXQ is used to isolate input signal grounds from chassis ground to prevent ground loops.
• Indicators
• Enable: This amber front panel indicator shows the on/off status of the low-voltage power supply.
• Signal/IOC: Each channel has a green front panel indicator that flashes to show amplifier output. If a channels output waveform differs from its input by 0.05% or more, the indicator flashes brightly to show distortion. This function provides proof of distortion-free performance. In Parallel-Mono mode, the Channel 2 light stays on.
• ODEP: Each channel has an amber front panel indicator that shows thermal-dynamic energy reserve. Normally, each ODEP indicator is lit to show available reserve energy. In the rare event that a channel has no reserve, its indicator will dim in proportion to ODEP limiting. An ODEP indicator may also turn off under other conditions.
• Input/Output
• Input Connector: Two balanced 1/4-inch phone jacks on the back panel and two balanced three-pin female XLR connectors on the factory-installed PIP2-FXQ.
• Input Impedance: Nominally 20 k ohms, balanced. Nominally 10 k ohms, unbalanced.
• Input Sensitivity: Settings include 0.775 volts or 1.4volts for standard 1 kHz power, or a 26 dB voltage gain.
• Output Connectors: Two sets of color-coded 5-way binding posts (for banana plugs, spade lugs or bare wire).
• Output Impedance: Less than 10 milliohms in series with less than 2 microhenries.
• DC Output Offset: (Shorted input) 10 millivolts.
• Output Signal
• Stereo: Unbalanced, two-channel.
• Bridge-Mono: Balanced, single-channel. Channel 1 controls are active; Channel 2 should not be used.
• Parallel-Mono: Unbalanced, single-channel. Channel 1 controls are active; Channel 2 controls are bypassed.
• Protection
• Macro-Tech amplifiers are protected against shorted, open or mismatched loads; overloaded power supplies; excessive temperature, chain destruction phenomena, input overload damage and high-frequency blowups. They also protect loudspeakers from input/output DC and turn-on/turn-off transients.
• If unreasonable operating conditions occur, the patented ODEP circuitry will proportionally limit the drive level to protect the output transistor stages, particularly in the case of elevated temperature. Transformer overheating will result in a temporary shutdown of the affected channel; when it has cooled to a safe temperature, the transformer will automatically reset itself. Controlled slew-rate voltage amplifiers prevent RF burnouts. And input overload protection is provided by current-limiting resistance at the input.
• Turn On: Four-second delay with no dangerous transients.
• Construction
• Steel chassis with durable black finish, aluminum front panel with Lexan overlay, and specially designed flow-through ventilation from front to side panels.
• Cooling: Internal heat sinks with forced-air cooling for rapid, uniform heat dissipation.
• Dimensions: Standard 19-inch (48.3-cm) rack mount width (EIA RS-310-B), 3.5-inch (8.9-cm) height, 16 inch (40.6-cm) depth behind the mounting surface and 2.5-inch (6.3- cm) protrusion in front of the mounting surface.
• Approximate Weight: Center of gravity is 6inches (15.2cm) behind front mounting surface.
• 120 VAC, 60 Hz Units:
• Macro-Tech 2402: 51pounds, 12 ounces (23.5kg) net; 65 pounds (29.5 kg) shipping weight.
• International Units:
• Macro-Tech 2402: 48pounds, 15 ounces (22.2kg) net; 57 pounds, 6 ounces (26.0 kg) shipping weight.

Get your Crown MA-2402 product today!

Accu Cable AER Akai AKG Alesis Allen & Heath Alto Alvarez American Audio American DJ Ampeg Anchor Audio Antari Antonio Hermosa Apex Applause Aria Armstrong Ashdown Audio Technica Auralex Avanti Axis AXL B.C. Rich Bach Behringer Benge Beyer Dynamic Boucher Bugera Casio Celestion Chauvet Conn Cordoba Cortex Crate Crown D'Aquisto Daisy Rock DB DBX DBZ Dean Denon Digidesign Digitech DW Drums Eden Elation Electro Harmonix Electro Voice Emerson EMG ESP Fender Acoustics Fender Amplifiers Fender Audio Fender Bass Amplification Fender Basses Fernandes Fog, Snow, & Bubble Machines Fostex Furman Galaxy Audio Gallien Krueger Galway Gator Gemini Genz Benz Gibraltar Glaesel Gretsch Guild Hagstrom Hammond Hartke Hayden Hiscox Hohner Holton Hosa Hughes And Kettner Ibanez Ikey Audio Jackson Jasmine Jay Turser JBL Johnson Jose Ramirez King KK Korg Kurzweil Kustom Laney Lanikai Latin Percussion LeBlanc Levy's Lexicon Loar Loriente Lucida Ludwig Luna Guitars M-Audio Mackie Marantz Marshall Martin Monster Moog Musser MXL Nady Nady Guitar Nady Pro Audio Nady Wireless Natal Native Instruments Nord Numark Odyssey Oscar Schmidt Ovation Pacific Paiste Palatino Paris Swing Parker Pearl Pearl Flutes Pearl Percussion Peavey Phonic Pioneer Prelude Presonus QSC Randall Rane RCF Recording King Sabian Sakurai Kohno Samick Samson Savannah Scherl and Roth Selmer Selmer Paris Sennheiser Seymour Duncan Silvertone Soundcraft Squier Bass Guitars Squier Electric Guitars Stanton SWR T-Rex Takamine Tama Tanglewood Tascam TC Electronic Musical Instruments TC Electronics Broadcast TC Electronics Computer Recording TC Electronics Pro TC Helicon Telex The Loar Toca Traynor Ultimate Support Vestax Vocopro Voodoo Labs Vox Warwick Washburn William lewis Yairi Yamaha Accessories Yamaha Arranger Workstation Yamaha Digital Pianos Yamaha Drums Yamaha Electronic Drums Yamaha Guitars Yamaha Keyboards Yamaha Live Sound Yamaha Music Production Yamaha Portable Keyboards Yanagisawa Zildjian Zoom